This article mainly refers to the experience of CoyoteDen on the official OpenWRT forum, and supplements the parts that are not detailed:.At the time of writing this article, WNDR4300 (v2) cannot flash OpenWRT, so it is uncertain whether this article is applicable to the v2 version.Then cancel the static IP, reconnect to the router with a network cable, visit 192.168.1.1, and try to see if the flashing is successful. After waiting, power off the router and turn it on again. To be on the safe side, it is recommended to wait for five minutes to avoid any premature interruption. According to my experience, the speed of flashing firmware is also very fast–perhaps fewer than 10 seconds.The reason for this is that the router has started flashing the firmware, and thus it rejected the second file upload request If the second command prompts that execution failed, it means that the first command was successful. If you want to confirm whether the transfer is complete, you can execute the command mentioned in item 8 again. Generally speaking, TFTP file transfer will be very fast, and there will be no prompt after the transfer.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |